Audi A7 3.0 TDI FWD 204hp Remap

The Audi A7 3.0 TDI FWD 204hp is a 3.0L turbocharged diesel engine producing 204 BHP and 400 Nm from the factory. With a typical Stage 1 remap, output increases to approximately 280 BHP and 600 Nm — a gain of around 76 BHP (37%) and 200 Nm (50%).

This engine scores highly for remap suitability, with gains weighted towards torque — you will notice the difference most strongly in mid-range pulling power and in-gear acceleration. The tuning headroom is classified as high, based on the percentage gain available from the factory output.

From a technical perspective, the ECU is a Bosch EDC17 (likely), and the transmission is manual and dsg/s tronic automatics are common depending on model/engine. some dsg/dual-clutch gearboxes have torque management; calibration may be torque-limited. at this torque level, transmission and driveline servicing history becomes especially important..

Considerations: High tuned torque: check transmission torque capacity and service history.. Large torque increase: drivetrain condition (clutch/gearbox) becomes more important at this level.

Fuel economy note: economy gains unlikely at full power; depends on driving style.

All figures shown are typical estimates based on aggregated Stage 1 data for this engine variant. Actual results depend on vehicle condition, mileage, and the chosen tuning method. We recommend discussing your specific vehicle with a qualified remap professional.