BMW 3 Series 330i 252hp Remap

The BMW 3 serie 330i 252hp is a 2.0L naturally aspirated petrol engine producing 252 BHP and 350 Nm from the factory. With a typical Stage 1 remap, output increases to approximately 300 BHP and 450 Nm — a gain of around 48 BHP (19%) and 100 Nm (29%).

This engine has moderate remap suitability, with gains weighted towards torque — you will notice the difference most strongly in mid-range pulling power and in-gear acceleration. The tuning headroom is classified as high, based on the percentage gain available from the factory output.

From a technical perspective, the transmission is many variants use zf 8-speed automatic (where fitted); manuals also exist. at this torque level, transmission and driveline servicing history becomes especially important..

Considerations: Naturally aspirated engine: gains are usually limited; results vary widely.. Unusually high gain for NA engine: treat as an estimate and verify against the exact engine variant.. High tuned torque: check transmission torque capacity and service history.. Large torque increase: drivetrain condition (clutch/gearbox) becomes more important at this level.

All figures shown are typical estimates based on aggregated Stage 1 data for this engine variant. Actual results depend on vehicle condition, mileage, and the chosen tuning method. We recommend discussing your specific vehicle with a qualified remap professional.