Considering an ECU remap for your Chevrolet S10 2.8 CDTi 200hp? A Stage 1 remap can take this 2012 -> diesel engine from 200 BHP to 235 BHP and from 500 Nm to 560 Nm of torque (turbocharged). This engine scores 6.5/10 for remap suitability. Get a free personalised quote from a trusted remap professional and find out exactly what your Chevrolet S10 can achieve.
Comparisons are calculated from our own recorded Stage 1 figures.
The Chevrolet S10 2.8 CDTi 200hp is a 2.8L turbocharged diesel engine producing 200 BHP and 500 Nm from the factory. With a typical Stage 1 remap, output increases to approximately 235 BHP and 560 Nm — a gain of around 35 BHP (18%) and 60 Nm (12%).
This engine has moderate remap suitability, with gains weighted towards peak power — the improvement is most noticeable at higher RPM. The tuning headroom is classified as moderate, based on the percentage gain available from the factory output.
Considerations: High tuned torque: check transmission torque capacity and service history.
Fuel economy note: possible improvement with conservative driving.
All figures shown are typical estimates based on aggregated Stage 1 data for this engine variant. Actual results depend on vehicle condition, mileage, and the chosen tuning method. We recommend discussing your specific vehicle with a qualified remap professional.
Get a personalised remap quote for your Chevrolet S10. We'll connect you with a trusted professional in your area.
All figures shown are typical estimates based on aggregated Stage 1 data for this engine variant. Actual results depend on vehicle condition, mileage, and the chosen tuning method.
We recommend discussing your specific vehicle with a qualified remap professional before proceeding.
