Considering an ECU remap for your Holden Captiva 2.4L 165hp? A Stage 1 remap can take this 2013 -> petrol engine from 165 BHP to 195 BHP and from 230 Nm to 290 Nm of torque (naturally aspirated). This engine scores 5.5/10 for remap suitability. Get a free personalised quote from a trusted remap professional and find out exactly what your Holden Captiva can achieve.
The Holden Captiva 2.4L 165hp is a 2.4L naturally aspirated petrol engine producing 165 BHP and 230 Nm from the factory. With a typical Stage 1 remap, output increases to approximately 195 BHP and 290 Nm — a gain of around 30 BHP (18%) and 60 Nm (26%).
This engine has moderate remap suitability, with gains weighted towards torque — you will notice the difference most strongly in mid-range pulling power and in-gear acceleration. The tuning headroom is classified as high, based on the percentage gain available from the factory output.
Considerations: Naturally aspirated engine: gains are usually limited; results vary widely.. Unusually high gain for NA engine: treat as an estimate and verify against the exact engine variant.. Large torque increase: drivetrain condition (clutch/gearbox) becomes more important at this level.
All figures shown are typical estimates based on aggregated Stage 1 data for this engine variant. Actual results depend on vehicle condition, mileage, and the chosen tuning method. We recommend discussing your specific vehicle with a qualified remap professional.
| Engine | BHP | Gain | Torque | Gain | Score |
|---|---|---|---|---|---|
| 2.2L 160hp | 160 → 190 | +30 | 350 → 410 | +60 | Good (7/10) |
Get a personalised remap quote for your Holden Captiva. We'll connect you with a trusted professional in your area.
All figures shown are typical estimates based on aggregated Stage 1 data for this engine variant. Actual results depend on vehicle condition, mileage, and the chosen tuning method.
We recommend discussing your specific vehicle with a qualified remap professional before proceeding.
