Audi Q7 3.0 TFSI 333hp Remap

The Audi Q7 3.0 TFSI 333hp is a 3.0L turbocharged petrol engine producing 333 BHP and 440 Nm from the factory. With a typical Stage 1 remap, output increases to approximately 400 BHP and 520 Nm — a gain of around 67 BHP (20%) and 80 Nm (18%).

This engine has moderate remap suitability, with a balanced spread of gains across both power and torque — providing a noticeable improvement across the rev range. The tuning headroom is classified as moderate, based on the percentage gain available from the factory output.

From a technical perspective, the ECU is typically a Bosch MED17 (likely), and the transmission is manual and dsg/s tronic automatics are common depending on model/engine. some dsg/dual-clutch gearboxes have torque management; calibration may be torque-limited. at this torque level, transmission and driveline servicing history becomes especially important..

Considerations: Turbo petrol: fuel quality and cooling can influence repeatable performance.. High tuned torque: check transmission torque capacity and service history.

All figures shown are typical estimates based on aggregated Stage 1 data for this engine variant. Actual results depend on vehicle condition, mileage, and the chosen tuning method. We recommend discussing your specific vehicle with a qualified remap professional.