BMW 3 Series M3 431hp Remap

The BMW 3 serie M3 431hp is a 3.0L naturally aspirated petrol engine producing 431 BHP and 550 Nm from the factory. With a typical Stage 1 remap, output increases to approximately 500 BHP and 650 Nm — a gain of around 69 BHP (16%) and 100 Nm (18%).

This engine has limited remap suitability, with a balanced spread of gains across both power and torque — providing a noticeable improvement across the rev range. The tuning headroom is classified as moderate, based on the percentage gain available from the factory output.

From a technical perspective, the transmission is many variants use zf 8-speed automatic (where fitted); manuals also exist. at this torque level, transmission and driveline servicing history becomes especially important..

Considerations: Naturally aspirated engine: gains are usually limited; results vary widely.. Unusually high gain for NA engine: treat as an estimate and verify against the exact engine variant.. High tuned torque: check transmission torque capacity and service history.

All figures shown are typical estimates based on aggregated Stage 1 data for this engine variant. Actual results depend on vehicle condition, mileage, and the chosen tuning method. We recommend discussing your specific vehicle with a qualified remap professional.