Iveco Cursor 10 - 400 - 400hp Remap

The Iveco Cursor 10 - 400 - 400hp is a turbocharged diesel engine producing 400 BHP and 1900 Nm from the factory. With a typical Stage 1 remap, output increases to approximately 480 BHP and 2300 Nm — a gain of around 80 BHP (20%) and 400 Nm (21%).

This engine scores highly for remap suitability, with a balanced spread of gains across both power and torque — providing a noticeable improvement across the rev range. The tuning headroom is classified as high, based on the percentage gain available from the factory output.

Considerations: High tuned torque: check transmission torque capacity and service history.

Fuel economy note: possible improvement with conservative driving.

All figures shown are typical estimates based on aggregated Stage 1 data for this engine variant. Actual results depend on vehicle condition, mileage, and the chosen tuning method. We recommend discussing your specific vehicle with a qualified remap professional.